100kV ~ 400kV Range
HCTT 250KV/10KVA Test Transformer
Home > Systems > AC Dielectric Test > AC Test Transformer > 100kV ~ 400kV Range

HCTT 250KV/10KVA Test Transformer

Lead time: 60 days

Mode: HCTT 250KV/10KVA
Cylinder type                                                                                           Rated input current: 50A
Single phase                                                                                             Rated output current: 0.04A
Frequency: 60Hz                                                                                     Cooling methods: ONAN
Rated Capacity: 10kVA                                                                           No-load current ≤10%
Rated input voltage: 0.4kV                                                                    Waveform deviation ≤5%
Rated output voltage: 250kV                                                                 Impedance voltage ≤10%
PD Level: <5pC at 100%UH of complete test system

Working for one hour on, one hour off allowed at 100% rated current & voltage;
Continuous working allowed at 80% rated current & voltage; and temperature rise of transformer winding is less than 65K, temperature rise of oil surface is less than 55K.

Dimension: Φ600*2100mm
Basement: 800mm*800mm
Top electrode:Φ900mm*350mm
Weight: 380kg

HCTT 250KV/10KVA Test Transformer HCTT 250KV/10KVA Test Transformer

HCTT 250KV/10KVA Test Transformer HCTT 250KV/10KVA Test Transformer
Transformer Oil: 
25# transformer oil is from Karamay Refinery. The oil indicator can reach the oil level for 500KV transformers. Factory test of test transformer should use new transformer oil supplying with transformers and perform oil inspection before or after factory test. Oil inspection report should be provided when the transformer delivered filled with oil. Quality of transformer oil should meet the requirements of SH0040-91, GB2536-90, GB7595-87, SD187-86, Class II A of IEC-296 standards. Components PCB are prohibited in the oil. When doing acceptance test on-site, the oil performance should satisfy the following requirements: DGA analysis of total hydrocarbons less than 10 mg/L, the breakdown voltage of the oil should not be less than 65kV/2.5mm, dielectric loss(90°C) is not more than 0.3%, water content is not more than 10mg/L, the gas content is not more than 1%.

Principle Diagram: 

  
Where To Buy

Related Photos

Related Products