HCTT 100kV/12kVA Test Transformer

Mode: HCTT 100kV12kVA
Cylinder type                                                              
HV current: 0.12A
Single phase                                                               
Cooling methods: ONAN
Frequency: 50Hz /60Hz                                 
No-load current ≤10%
Rated Capacity: 12kVA                                               
Waveform deviation ≤5%
HV winding: 100kV                                                   
Impedance voltage ≤10%
PD Level:<2pC at 100%UH of complete test system

Over-current capability: Working for 300s allowed at 150%In, not cause any damage to transformer winding and insulation.
Over-voltage capability: Working for 60s allowed at 110% rated current, not cause any damage to transformer insulation.
Insulation level: withstand 3kV/min (Low voltage input ending to ground)
Working time: working 60 minutes under 100% rated voltage; Continuous working allowed at 80% rated current & voltage; and  temperature rise of transformer winding is less than 65K, temperature rise of oil surface is less than 55K.
Weight: 200kg (approx.)

 
Transformer Oil: 
25# transformer oil is from Karamay Refinery. The oil indicator can reach the oil level for 500KV transformers. Factory test of test transformer should use new transformer oil supplying with transformers and perform oil inspection before or after factory test. Oil inspection report should be provided when the transformer delivered filled with oil. Quality of transformer oil should meet the requirements of SH0040-91, GB2536-90, GB7595-87, SD187-86, Class II A of IEC-296 standards. Components PCB are prohibited in the oil. When doing acceptance test on-site, the oil performance should satisfy the following requirements: DGA analysis of total hydrocarbons less than 10 mg/L, the breakdown voltage of the oil should not be less than 65kV/2.5mm, dielectric loss(90°C) is not more than 0.3%, water content is not more than 10mg/L, the gas content is not more than 1%.

Principle Diagram: