HCTT 20kV/20kVA Test Transformer

Mode: HCTT 20KV/20KVA
Cylinder type, movable                                                                      HV current: 1A
Single phase                                                                                        Rated current: 40A
Frequency: 50Hz                                                                                Cooling methods: ONAN
Rated Capacity: 20kVA                                                                      Waveform deviation ≤5%
Rated input voltage: 0.40kV                                                             Impedance voltage ≤5%
HV winding: 20kV                                                                              Measuring winding voltage ratio: 1000:1

Over-current capability: Working for 300s allowed at 150%In, without any damage to transformer winding and insulation.
Over-voltage capability: Working for 60s allowed at 110% rated current, without any damage to transformer insulation.
Insulation level: withstand 3kV/min (Low voltage input ending to ground)
PD level: ≤5pC at rated voltage               Dielectric loss: <0.5%
Working time: working 60 minutes under 100% rated voltage; Continuous working allowed at 80% rated current & voltage; and temperature rise of transformer winding is less than 65K, temperature rise of oil surface is less than 55K.
Dimension: 300mm*400mm*400mm              Weight: <50kg

 

Transformer Oil: 
25# transformer oil is from Karamay Refinery. The oil indicator can reach the oil level for 500KV transformers. Factory test of test transformer should use new transformer oil supplying with transformers and perform oil inspection before or after factory test. Oil inspection report should be provided when the transformer delivered filled with oil. Quality of transformer oil should meet the requirements of SH0040-91, GB2536-90, GB7595-87, SD187-86, Class II A of IEC-296 standards. Components PCB are prohibited in the oil. When doing acceptance test on-site, the oil performance should satisfy the following requirements: DGA analysis of total hydrocarbons less than 10 mg/L, the breakdown voltage of the oil should not be less than 65kV/2.5mm, dielectric loss (90°C)is not more than 0.3%, water content is not more than 10mg/L, the gas content is not more than 1%.

Principle Diagram: