≤100kVA Range
HET 66kVA/6.6kV,3.85kV,2.2kV Exciter Transformer
Home > Systems > Inductance Resonant > Exciting Transformer > ≤100kVA Range

HET 66kVA/6.6kV,3.85kV,2.2kV Exciter Transformer

Lead time: 45 days

Mode: HET 66kVA/6.6kV,3.85kV,2.2kV
Rated capacitance: 66kVA
Single phase
Rated frequency:50Hz
Cooling methods: ONAN
Rated input voltage: 415V
Output voltage: Tap I:6.6kV Tap II:3.85kV Tap III:2.2kV
Output current: Tap I:10A Tap II:17A Tap III:30A
Impedance voltage: <5%

Shielding methods: Set electrostatic shield layer between HV winding and LV winding

HET 66kVA/6.6kV,3.85kV,2.2kV Exciter Transformer,Inductance Resonant System HET 66kVA/6.6kV,3.85kV,2.2kV Exciter Transformer,Inductance Resonant System

HET 66kVA/6.6kV,3.85kV,2.2kV Exciter Transformer,Inductance Resonant System HET 66kVA/6.6kV,3.85kV,2.2kV Exciter Transformer,Inductance Resonant System

Exciter transformer protection: equip piezoresistor for each HV output, exciter transformer’s input and output terminal connects with the ground via zinc oxide arrester, this methods can protect the operator and the equipment itself when test object breakdown. Structure: steel housing, HV bushing equips on the oil tank, equips wheels, movable, oil tank is shell-type, lead out the Low voltage with porcelain bushing. E ach terminal is lead out by relative voltage grade bushing. HV bushing lead wire go through isovolumetric capacitance core, exterminal insulation is fiber glass bushing. Bushing has corona rings. Oil tank has oil conservator to make sure the capacitance core in the oil. HV bushing can guarantee 6.6kV corona free. Exciter transformer insulation characteristic: Exciter transformer insulation levelwill determin transformer’s safety work and insulation ageing speed. To guarantee no flashover- which coming from external, electric potential raise and cause damage to the main insulation and minor insulation. We will also set insulation layer between HV windings and turn-to-turn. Winding is cylinder type. Capacitance is determin by the winding’s area.   When design, we’d try our best to make sure the top and bottom has same area, and compensate with electrostatic shield to improve the initial voltage distribution. Winding skeleton is made of compound insulation tube: can get down partial discharge and shielding the iron coil.

Principle Diagram: 

Where To Buy